Grab Rail with Single Toilet Roll Holder

Produkt Information
Specification

SAFETY GRAB RAIL HANDRAIL WITH SINGLE TOILET ROLL HOLDER

Material: 304 Grade Stainless Steel

Material Size: 32mm round Tube

Material Finish: Polished/ Mirror (chrome appearance) also available in Satin Black, Ultra White or Safety Yellow.

Distance between back of wall and back of rail: 50mm

Internal fitting: Brass and Stainless Steel Screws (304 Grade) - all supplied.

Fixing Type: Ramset Wall Plugs for 8mm hole into Masonry (supplied) and stainless Steel Screws (supplied)

Fixing Spacing: Horizontal - 300 mm Vertically - 132 mm

Tools Required: M6 Allen Key (supplied), Phillips head screw driver (not supplied ), 8mm diamond hole saw (not supplied), level (not supplied), Tape measure (not supplied) and Silcon (not supplied)

GST: Included in Sale Price

Compliance With Australian Standard AS 1428.1 - 2009 Design for Access and Mobility

Clause 17 (a) - outside diameter 32 mm - COMPLIANT

Clause 17 (b) - all exposed edges and corners have a radius greater than 5mm - COMPLIANT

Clause 17 (c) - Grabrail constructed to withstand forces of 1100N applied in any position and direction without deforming internal fastenings or fixings - COMPLIANTPLEASE NOTE IT IS THE RESPONSIBILITY OF THE INSTALLER TO ENSURE THAT THE HANDRAIL IS FIXED TO THE WALL IN AN APPROPRIATE WAY TO ENSURE COMPLIANCE WITH THE INSTALLATION COMPOUND OF THIS REQUIREMENT - IF IN-DOUBT PLEASE CONSULT YOUR BUILDING CERTIFIER OR ENGINEER - THIS IS SOMETHING WE CANNOT ADVISE ON.

Clause 17 (d) The Clearance between the grab rail and adjacent wall surface is 50mm. COMPLIANT PLEASE NOTE THIS CLAUSE ALSO REQUIRES THE GRAB RAIL TO HAVE CLEARANCE OF 600 MM ABOVE IT - THIS IS THE RESPONSIBILITY OF THE INSTALLER

Clause 17 (e) The Grabrail is designed so it can be fixed where there are not obstructions to the passage of the handle along the top 270 degree arch of the horizontal surface - COMPLIANT

Produkt Kode	GRTRHS
Condition	New

Produkt Information